AsyncLabs Forums

[DrStu]

Hi all,

I've new here, just started using my YJ. I followed through the instructions in wiki (changing the headers in the library code). Also i have changed the parameters in the sketch , giving it ip and the router's password etc etc.

On the software side, I've modified the IP too and run it. Unfortunately, all i get is a "hello" , which means that i'm not getting a reply from the YJ i guess.

The funny thing is, I tried a ping to the YJ and did get a response.

(I have only two devices connected to my router btw)

Any suggestions on detecting the error is greatly appreciated~!

PS: Just checked in my router config page, the IP of the YJ is NOT actually listed as connected to it. Am I expecting to see the IP of the YJ listed there if it has succesfully connected to the router?

[DrStu]

Ok got the board to connect to the router (Verified from the router config page - an 'unknown' device connected with the YJ's IP i specified.

The problem was with my router, it was supported but the wpa2 security on it wasn't
viewtopic.php?f=13&t=13 - List of working routers


Nevertheless, I'm still not able to get the software running as it should. All i see is a "Hello" ....and dead silence, no reply, wad could be wrong with it?

Appreciate your help all

[GregEigsti]

Give the code on this thread a try; you will need to use both the Arduino/WiShield as well as PC code.

viewtopic.php?f=15&t=361&start=10

Greg

[DrStu]

WOW! Works flawlessly!

I was actually scanning through dat forum post when you replied ^^ . Took about 3 mins to reconfigure your code and it just worked miraculously! I'm very grateful for your help Greg

At least now I know my hardware , router etc are working fine Just wondering why the UDPApp didn't work.

I'll try it again as I would like my PC to initiate (send the 1st packet) while the YJ just listens on (conserving power is not important for me^^) .

Thanks again Greg

[GregEigsti]

Glad that it worked for you! The out of the box UDP sample has worked for me but is probably not the best bit of sample code

Greg